Potentiometer JP-30
- ●To make a purchase, contact Distributors, or use e-commerce below.
SALES CHANNEL ;Check our Distributors.- SALES CHANNELClick here to check our Distributors.
CERMET SINGLE TURN TYPE
- Cost effective (In house comparison)
- High resoluiion (Essentially infinite)
- RoHS compliant
Resistance torelance | ± 2% |
---|---|
Resolution | Essentially infinite |
Independent linearity | ± 0. |
Effective electrical angle | 300° ± 1° |
Mechanical angle | 360° continuous |
Power rating (at 40 °C) | 1.5W |
Dielectric strength | 1000 Vrms 1 min |
Insulation resistance | 1000 MΩ minimum(at DC500 V) |
Rotational torque | 2.94 {30} mN·m {gf·cm} maximum |
Peak noise | 2 % or 100 Ω, whichever is greater |
Temp. coefficient of resistance | ± 150 10-6/°C |
Operating temp. range | − 55 ~ 85°C |
Maximum rotational speed | 150 r/min |
Rotational life | 3 million revolution |
Net weight | Approx. 26g |
Strength of tighten screw | 0.98 N·m {10 kgf·cm} maximum |
- Perform soldering of the terminals at 380 °C for no more three seconds, and avoid applying excess heat. Also, avoid applying outside force to the terminals.
In case of using multiturn potentiometers, when rotating the shaft to the mechanical limit, apply torque below the strength of the stopper. Also, give due consideration to thrust and radial loading.
PART NUMBER DESIGNATION
JP-30- | 1K |
---|---|
Series name JP-30:For sensor |
Nominal resistance value(Ω) 500, 1 k, 2 k, 5 k, 10 k, 20 k, 50 k, 100 k |
LIST OF PART NUMBERS
Part number | Nominal resistance value |
---|---|
JP-30 500 | 500 Ω |
JP-30 1 k | 1 kΩ |
JP-30 2 k | 2 kΩ |
JP-30 5 k | 5 kΩ |
JP-30 10 k | 10 kΩ |
JP-30 20 k | 20 kΩ |
JP-30 50 k | 50 kΩ |
JP-30 100 k | 100 kΩ |
NOMINAL RESISTANCE VALUE • RATED VOLTAGE • RATED CURRENT
Nominal resistance value(Ω) | Rated voltage(V) | Rated current(mA) |
---|---|---|
500 | 27.3 | 54.7 |
1 k | 38.7 | 38.7 |
2 k | 54.7 | 27.3 |
5 k | 86.6 | 17.3 |
10k | 122 | 12.2 |
20 k | 173 | 8.66 |
50 k | 273 | 5.47 |
100 k | 387 | 3.87 |
RATED POWER DERATING CURVE
|
OUTLINE DIMENSIONS
Unless otherwise specified, tolerance: ± 0.5 (Unit: mm)
![](/file/img/ji-30_out.png)
Documents
- ●The above contents and descriptions are subject to change without notice.